Dell PowerConnect 6224 Command Line Interface Manual page 575

dvlan-tunnel ethertype
Use the dvlan-tunnel ethertype command in Global Configuration mode to
configure the ethertype for the specified interface.
To configure the EtherType on the specified interface to its default value, use
the no form of this command.
Syntax
dvlan-tunnel ethertype {802.1Q | vman | custom <
no dvlan-tunnel ethertype
• 802.1Q — Configures the EtherType as 0x8100.
• vman — Configures the EtherType as 0x88A8.
• custom — Custom configures the EtherType for the DVLAN tunnel. The
value must be 0-65535.
Default Configuration
The default for this command is 802.1Q.
Command Mode
Global Configuration
User Guidelines
This command has no user guidelines.
Example
The following example displays configuring Double VLAN tunnel for vman
EtherType.
console(config)#dvlan-tunnel ethertype vman
interface vlan
Use the interface vlan command in Global Configuration mode to configure
a VLAN type and to enter Interface Configuration mode.
0-65535
>}
VLAN Commands
575