Area Virtual-Link Retransmit-Interval - Dell PowerConnect 6224 Command Line Interface Manual

User Guidelines
This command has no user guidelines.
Example
The following example configures a 50-second wait interval.
console(config-router)#area 10 virtual-link
192.168.2.2 hello-interval 50

area virtual-link retransmit-interval

Use the area virtual-link retransmit-interval command in Router OSPF
Configuration mode to configure the retransmit interval for the OSPF virtual
interface on the virtual interface identified by the area ID and neighbor ID.
Use the no form of the command to return the retransmit interval to the
default value.
Syntax
area-id
area virtual-link
area-id
no area
area-id — Identifies the OSPF area to configure. (Range: IP address or
•
decimal from 0–4294967295)
neighbor-id — Identifies the Router ID of the neighbor.
•
seconds — The number of seconds to wait between retransmitting LSAs if
•
no acknowledgement is received. (Range: 0–3600)
Default Configuration
The default configuration is 5 seconds.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
870
OSPF Commands
neighbor-id
neighbor-id
virtual-link
retransmit-interval
retransmit-interval
seconds