Dos-Control Tcpflag; Dos-Control Tcpfrag - Dell PowerConnect 6224 Command Line Interface Manual

dos-control tcpflag

Use the dos-control tcpflag command in Global Configuration mode to
enable TCP Flag Denial of Service protections. If the mode is enabled, Denial
of Service prevention is active for this type of attack. If packets ingress having
TCP Flag SYN set and a source port less than 1024, having TCP Control
Flags set to 0 and TCP Sequence Number set to 0, having TCP Flags FIN,
URG, and PSH set and TCP Sequence Number set to 0, or having TCP Flags
SYN and FIN both set, the packets are dropped.
Syntax
dos-control tcpflag
no dos-control tcpflag
Default Configuration
Denial of Service is disabled.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example activates TCP Flag Denial of Service protections.
console(config)#dos-control tcpflag

dos-control tcpfrag

Use the dos-control tcpfrag command in Global Configuration mode to
enable TCP Fragment Denial of Service protection. If the mode is enabled,
Denial of Service prevention is active for this type of attack. If packets ingress
having IP Fragment Offset equal to one (1), the packets are dropped.
Syntax
dos-control tcpfrag
1135
Denial of Service Commands