Switchport Protected - Dell PowerConnect 6224 Command Line Interface Manual

Default Configuration
The default for this command is access.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures 1/g8 to access mode.
console(config)#interface ethernet 1/g8
console(config-if-1/g8)#switchport mode access

switchport protected

Use the switchport protected command in Interface Configuration mode to
groupid
configure a protected port. The parameter identifies the set of
protected ports to which this interface is assigned. You can only configure an
interface as protected in one group. You are required to remove an interface
from one group before adding it to another group.
Port protection occurs within a single switch. Protected port configuration
does not affect traffic between ports on two different switches. No traffic
forwarding is possible between two protected ports.
Syntax
groupid
switchport protected
no switchport protected
groupid- -Identifies which group this port will be protected in. (Range: 0-2)
•
Default Configuration
No protected switchports are defined.
598
VLAN Commands