Show Interfaces Tunnel - Dell PowerConnect 6224 Command Line Interface Manual

interface tunnel
Use the interface tunnel command in Global Configuration mode to enter
the interface configuration mode for a tunnel.
Syntax
interface tunnel
no interface tunnel
tunnel-id — Tunnel identifier. (Range: 0–7)
•
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables the interface configuration mode for tunnel 1.
console(config)#interface tunnel 1
console(config-if-tunnel1)#

show interfaces tunnel

Use the show interfaces tunnel command in Privileged EXEC mode to
display the parameters related to tunnel such as tunnel mode, tunnel source
address and tunnel destination address.
Syntax
show interfaces tunnel [
tunnel-id — Tunnel identifier. (Range: 0–7)
•
1032
Tunnel Interface Commands
tunnel-id
tunnel-id
tunnel-id
]