Area Virtual-Link - Dell PowerConnect 6224 Command Line Interface Manual

area-id
no area
area-id — Identifies the OSPF area to configure. (Range: IP address or
•
decimal from 0–4294967295)
Default Configuration
Disabled is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example prevents the Summary LSA from being advertised
into the area 3 NSSA.
console(config-router)#area 3 stub no-summary

area virtual-link

Use the area virtual-link command in Router OSPF Configuration mode to
create the OSPF virtual interface for the specified area-id and neighbor
router. To remove the link, use the no form of the command.
Syntax
area-id
area virtual-link
area-id
no area
area-id — Identifies the OSPF area to configure. (Range: IP address or
•
decimal from 0–65535)
neighbor-id — Valid IP address.
•
Default Configuration
This command has no default configuration.
866
OSPF Commands
stub no-summary
neighbor-id
neighbor-id
virtual-link