Default Configuration
ICMP Redirect messages are enabled by default.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan10)#ip redirects
ipv6 icmp error-interval
Use the icmp error-interval command to limit the rate at which ICMP error
messages are sent. The rate limit is configured as a token bucket with two
configurable parameters: Burst-size and burst interval. Use the "no" form of
this command to return burst-interval and burst-size to their default values.
To disable ICMP rate limiting, set burst-interval to zero.
Syntax
ipv6 icmp error-interval
no ipv6 icmp error-interval
burst-interval — How often the token bucket is initialized (Range:
•
0–2147483647 milliseconds).
burst-size — The maximum number of messages that can be sent during a
•
burst interval (Range: 1–200).
Default Configuration
Rate limiting is enabled by default.
The default burst-interval is 1000 milliseconds.
The default burst-size is 100 messages.
burst-interval
burst-size
[
]
Denial of Service Commands
1139