Snmp-Server V3-Host - Dell PowerConnect 6224 Command Line Interface Manual

snmp-server v3-host

Use the snmp-server v3-host command in Global Configuration mode to
specify the recipient of Simple Network Management Protocol Version 3
notifications. To remove the specified host, use the no form of this command.
Syntax
snmp-server v3-host {
[noauth | auth | priv] [timeout
filtername
[filter
no snmp-server host
ip-address — Specifies the IPv4 address of the host (targeted recipient).
•
hostname — Specifies the name of the host. (Range: 1-158 characters.)
•
username — Specifies user name used to generate the notification.
•
(Range: 1-25 characters.)
• traps — Indicates that SNMP traps are sent to this host.
informs — Indicates that SNMPv2 informs are sent to this host.
•
• noauth — Specifies sending of a packet without authentication.
• auth — Specifies authentication of a packet without encrypting it
• priv — Specifies authentication and encryption of a packet.
seconds — Number of seconds to wait for an acknowledgment before
•
resending informs. This is not allowed for hosts configured to send traps.
The default is 15 seconds. (Range: 1-300 seconds.)
retries — Maximum number of times to resend an inform request. This is
•
not allowed for hosts configured to send traps. The default is 3 attempts.
(Range: 0-255 retries.)
port — UDP port of the host to use. The default is 162. (Range: 1-65535.)
•
filtername — A string that is the name of the filter that define the filter for
•
this host. If unspecified, does not filter anything. (Range: 1-30 characters.)
Default Configuration
Default configuration is 3 retries and 15 seconds timeout.
1260
SNMP Commands
ip-address
|
seconds
]
ip-address
hostname username
}
retries
] [retries
{traps | informs}
port
] [udpport ]