Show Fiber-Ports Optical-Transceiver - Dell PowerConnect 6224 Command Line Interface Manual

show fiber-ports optical-transceiver

Use the show fiber-ports optical-transceiver command in Privileged EXEC
mode to display the optical transceiver diagnostics.
Syntax
show fiber-ports optical-transceiver [
interface — A valid Ethernet port. The full syntax is unit / port.
•
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
The show fiber ports command is only applicable to the SFP combo ports and
XFP ports (not the ports on the SFP+ plug-in module).
Examples
The following examples display the optical transceiver diagnostics.
console#show fiber-ports optical-transceiver
Port
TX LOS
Fault
-----------
----- ---
1/g3
OK OK
1/g4
E OK
1/g1
1166
PHY Diagnostics Commands
Temp Voltage
------ -------
w OK
OK OK
Copper
interface
]
Current
-------
E
OK
Output Input
Power Power
------ -----
OK OK
OK OK