Dell PowerConnect 6224 Command Line Interface Manual page 900

Router ID
OSPF Admin
Mode
RFC 1583
Compatibility
External LSDB
Limit
Exit Overflow
Interval
Spf Delay Time
Spf Hold Time
Opaque Capability Shows whether router is capable of sending Opaque LSAs.
AutoCost Ref BW The configured autocost reference bandwidth. This value is used
Default Passive
Setting
Maximum Paths
Default Metric
Default Route
Advertise
Always
900
OSPF Commands
A 32-bit integer in dotted decimal format identifying the router
about which information is displayed. This is a configured value.
Shows whether OSPF is administratively enabled or disabled.
This configuration option controls the preference rules used
when choosing among multiple external LSAs advertising the
same destination. When enabled, the preference rules remain
those specified by RFC 1583. When disabled, the preference
rules are those stated in Section 16.4.1 of RFC 2328. These rules
prevent routing loops when external LSAs for the same
destination have been originated from different areas.
Shows the maximum number of non-default external LSAs
entries that can be stored in the link-state database.
Shows the number of seconds that, after entering
OverflowState, as defined by RFC 1765, a router will attempt to
leave OverflowState.
The number of seconds to wait before running a routing table
calculation after a topology change.
The minimum number of seconds between routing table
calculations.
to determine the OSPF metric on its interfaces. The reference
bandwidth is divided by the interface speed to compute the
metric.
When enabled, OSPF interfaces are passive by default.
Shows the maximum number of paths that OSPF can report for
a given destination.
Default metric for redistributed routes.
When enabled, OSPF originates a type 5 LSA advertising a
default route.
When this option is configured, OSPF only originates a default
route when the router has learned a default route from another
source.