Timeout - Dell PowerConnect 6224 Command Line Interface Manual

Default Configuration
The IP address is of the outgoing IP interface.
Command Mode
Radius mode
User Guidelines
User must enter the mode corresponding to a specific Radius server before
executing this command.
Example
The following example specifies 10.240.1.23 as the source IP address.
console(config)#radius-server host 192.143.120.123
console(config-radius)#source-ip 10.240.1.23

timeout

Use the timeout command in Radius mode to set the timeout value in
seconds for the designated Radius server.
Syntax
timeout
timeout
timeout — Timeout value in seconds for the specified server. (Range: 1-30
•
seconds.)
Default Configuration
The default value is 3 seconds.
Command Mode
Radius mode
User Guidelines
User must enter the mode corresponding to a specific Radius server before
executing this command.
RADIUS Commands
519