Default Configuration
By default, these ports are configured as stacking ports.
Command Mode
Stack Configuration mode
User Guidelines
The clear config command will not change the stacking port mode. Only the
stack-port command can change the operating mode of the stacking port and
it only takes effect after a reboot when changing between stacking and
Ethernet mode. If this command is used with a CX-4 module, the ports will
be forced to Ethernet mode upon reboot.
Example
console(config-stack)#stack-port 1/xg3 ethernet
console(config-stack)#
standby
Use the standby command to configure the standby in the stack. This unit
comes up as the master when the stack failover occurs. Use the no form of
this command to reset to default, in which case, FASTPATH automatically
selects a standby from the existing stack units if there no preconfiguration.
Syntax
unit
standby
unit — Valid unit number in the stack. (Range: 1–12 maximum. The range
•
is limited to the number of units available on the stack.)
Default Configuration
This command has no default configuration.
Command Mode
Stack Global Configuration
1338
System Management Commands