Ipv6 Mld Last-Member-Query-Count; Ipv6 Mld Last-Member-Query-Interval - Dell PowerConnect 6224 Command Line Interface Manual

ipv6 mld last-member-query-count

The ipv6 mld last-member-query-count command sets the number of
listener-specific queries sent before the router assumes that there are no local
members on the interface. Use the "no" form of this command to set the last
member query count to the default.
Syntax
last-member-query-count
ipv6 mld last-member-query-count
no ipv6 mld last-member-query-count
last-member-query-count — Query count (Range: 1–20).
•
Default Configuration
The default last member query count is 2.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld last-member-query-
count 5

ipv6 mld last-member-query-interval

The ipv6 mld last-member-query-interval command sets the last member
query interval for the MLD interface, which is the value of the maximum
response time parameter in the group-specific queries sent out of this
interface. Use the "no" form of this command to set the last member query
interval to the default.
Syntax
last-member-query-interval
ipv6 mld last-member-query-interval
772
IPv6 Routing Commands