Snmp-Server Enable Traps Authentication - Dell PowerConnect 6224 Command Line Interface Manual

Example
The following example displays the options for the snmp-server enable traps
command.
console(config)#snmp-server enable traps ?
<cr>
acl
all
authentication
traps when
dvmrp
link
Up/Down trap flag.
multiple-users
multiple logins
ospf
ospfv3
pim
spanning-tree
Tree traps.

snmp-server enable traps authentication

Use the snmp-server enable traps authentication command in Global
Configuration mode to enable the switch to send Simple Network
Management Protocol traps when authentication fails. To disable SNMP
failed authentication traps, use the no form of this command.
Syntax
snmp-server enable traps authentication
no snmp-server enable traps authentication
Press enter to execute the command.
acl
Enable/Disable all Traps.
To enable the device to send SNMP
authentication fails.
dvmrp
Enable/Disable switch level Link
Enable/Disable sending traps when
active.
Enable/Disable OSPF Traps.
Enable/Disable OSPF Traps.
pim
Enable/Disable sending Spanning
SNMP Commands
1249