Rmon Alarm - Dell PowerConnect 6224 Command Line Interface Manual

rmon alarm

Use the rmon alarm command in Global Configuration mode to configure
alarm conditions. To remove an alarm, use the no form of this command. Also
see the related show rmon alarm command.
Syntax
index variable interval rthreshold fthreshold revent fevent
rmon alarm
type
] [startup
no rmon alarm
index — The alarm index. (Range: 1–65535)
•
variable — A fully qualified SNMP object identifier that resolves to a
•
particular instance of an MIB object.
interval — The interval in seconds over which the data is sampled and
•
compared with the rising and falling thresholds. (Range: 1–4294967295)
rthreshold — Rising Threshold. (Range: 0–4294967295)
•
fthreshold — Falling Threshold. (Range: 0–4294967295)
•
revent — The index of the Event that is used when a rising threshold is
•
crossed. (Range: 1- 65535)
fevent — The Event index used when a falling threshold is crossed.
•
(Range: 1- 65535)
type — The sampling method for the selected variable and
• type
calculating the value to be compared against the thresholds. If the method
is absolute, the value of the selected variable is compared directly with the
thresholds at the end of the sampling interval. If the method is delta, the
selected variable value at the last sample is subtracted from the current
value, and the difference compared with the thresholds.
direction — The alarm that may be sent when this entry is first set
startup
•
to valid. If the first sample (after this entry becomes valid) is greater than
or equal to the
then a single rising alarm is generated. If the first sample (after this entry
becomes valid) is less than or equal to the
equal to falling or rising-falling, then a single falling alarm is generated.
name — Enter a name that specifies who configured this alarm. If
• owner
unspecified, the name is an empty string.
1180
RMON Commands
direction
] [owner
index
rthreshold , and direction is equal to rising or rising-falling,
name
]
fthreshold , and direction is
[type