Stack; Stack-Port - Dell PowerConnect 6224 Command Line Interface Manual

1 K.3.9.1
2 K.3.9.1

stack

Use the stack command in Global Configuration mode to set the mode to
Stack Global Config.
Syntax
stack
Default Configuration
This command has no default mode.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the mode to Stack Global Config.
console(config)#stack
console(config-stack)#

stack-port

Use the stack-port command in Stack Configuration mode to configure Stack
ports as either Stacking ports or as Ethernet ports. This command is used to
configure CX-4 ports to be either stacking or Ethernet ports. By default, CX-4
ports are Ethernet ports.
Syntax
unit
stack-port <
0.0.0.0
0.0.0.0
port-type
>/< ><
image1
image1
port-num ethernet
> {
System Management Commands
image1
image1
stack
| }
1337