Dell PowerConnect 6224 Command Line Interface Manual page 619

dot1x mac-auth-bypass
Use the dot1x mab-enable command to enable MAB on an interface. Use the
"no" form of this command to disable MAB on an interface.
Syntax
dot1x mac-auth-bypass
no dot1x mac-auth-bypass
Default Configuration
MAC Authentication Bypass is disabled by default.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets MAC Authentication Bypass on interface 1/2:
console(config-if-1/g2)#dot1x mac-auth-bypass
dot1x max-req
Use the dot1x max-req command in Interface Configuration mode to set the
maximum number of times that the switch sends an Extensible
Authentication Protocol (EAP)-request frame (assuming that no response is
received) to the client before restarting the authentication process. To return
to the default setting, use the no form of this command.
Syntax
count
dot1x max-req
no dot1x max-req
count — Number of times that the switch sends an EAP-request/identity
•
frame before restarting the authentication process. (Range: 1–10)
802.1x Commands
619