Area Virtual-Link Transmit-Delay - Dell PowerConnect 6224 Command Line Interface Manual

Example
The following example configures the retransmit interval of 20 seconds for
the OSPF virtual interface on the virtual interface identified by area 1 and its
neighbor.
(config)#ipv6 router ospf
(config-rtr)#area 1 virtual-link 2 retransmit-
interval 20

area virtual-link transmit-delay

Use the area virtual-link transmit-delay command in Router OSPFv3
Configuration mode to configure the transmit delay for the OSPF virtual
interface on the virtual interface identified by
Syntax
areaid
area virtual-link
areaid
no area
areaid — Valid OSPFv3 area identifier.
•
neighbor — Router ID of neighbor.
•
seconds — Transmit delay interval. (Range: 0-3600)
•
Default Configuration
1 is the default value for
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures a 20-second transmit delay for the OSPF
virtual interface on the virtual interface identified by area 1 and its neighbor.
console(config)#ipv6 router ospf
946
OSPFv3 Commands
neighbor
neighbor
virtual-link
seconds
areaid
seconds
transmit-delay
transmit-delay
.
neighbor
and .