Permit (Management) - Dell PowerConnect 6224 Command Line Interface Manual

console(config-macal)# permit ethernet 1/g1 priority
<1-64>
console(config-macal)# permit ethernet 2/g9 priority
<1-64>
console(config-macal)# exit
console(config)#management access-class mlist
The following example shows how to configure all the interfaces to be
management interfaces except for two interfaces, Ethernet 1/g1 and Ethernet
2/g9.
console(config)# management access-list mlist
console(config-macal)# deny ethernet 1/g1 priority
<1-64>
console(config-macal)# deny ethernet 2/g9 priority
<1-64>
console(config-macal)# permit priority <1-64>
console(config-macal)# exit
console(config) # management access-class mlist

permit (management)

Use the permit command in Management Access-List configuration mode to
set conditions for the management access list.
Syntax
permit ip-source
number vlan-id
| vlan
priority-value
]
permit { ethernet
service
[service ] [priority
service
permit service
priority-value
permit priority
interface-number — A valid routed port number.
ethernet
•
ip-address
[ mask
|port-channel
interface-number
priority-value
priority-value
[priority
mask prefix-length
|
number
] [ service
vlan-id
| vlan | port-channel
]
]
Management ACL Commands
interface-
] [ethernet
service
] [ priority
number
}
1153