Ip Route - Dell PowerConnect 6224 Command Line Interface Manual

no ip netdirbcast
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example defines the IP address and subnet mask for VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ip netdirbcast

ip route

Use the ip route command in Global Configuration mode to configure a
static route. Use the no form of the command to delete the static route. The
IP route command sets a value for the route preference. Among routes to the
same destination, the route with the lowest preference value is the route
entered into the forwarding database. Specifying the preference of a static
route controls whether a static route is more or less preferred than routes from
dynamic routing protocols. The preference also controls whether a static
route is more or less preferred than other static routes to the same
destination.
Syntax
ip addr
ip route {
ip addr
no ip route
ip-address — IP address of destination interface.
•
subnet-mask — Subnet mask of destination interface.
•
subnetmask prefix length
|
subnetmask
{ |
nextHopRtr
}
prefix length nextHopRtr
}
IP Routing Commands
preference
[ ]
preference
[ ]
723