No Standby - Dell PowerConnect 6224 Command Line Interface Manual

Default Configuration
This command has no default configuration.
Command Mode
Stack Global Configuration mode
User Guidelines
Upon execution, the entire stack, including all interfaces in the stack, are
unconfigured and reconfigured with the configuration on the new
Management Switch.
After the reload is complete, all stack management capability must be
performed on the new Management Switch.
To preserve the current configuration across a stack move, execute the copy
configuration command before performing the stack move. A stack move
causes all routes and layer 2 addresses to be lost. This command is executed
on the Management Switch. The administrator is prompted to confirm the
management move.
Example
The following example displays how to move the Management Switch
functionality from switch "1" to switch "8."
console(config)#stack
console(config)#movemanagement 1 2

no standby

Use the no standby command to unconfigure the standby in the stack. In this
case, FASTPATH automatically selects a standby from the existing stack
units.
Syntax
no standby
Default Configuration
This command has no default configuration.
1300
System Management Commands