Sflow Sampling - Dell PowerConnect 6224 Command Line Interface Manual

The default poll interval is 0.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
console(config-if-1/g2)#sflow 1 polling 6055

sflow sampling

Use the sflow sampling command to enable a new sflow sampler instance for
this data source if rcvr_idx is valid. Use the "no" form of this command to
reset sampler parameters to the default.
Syntax
rcvr-index
sflow sampling ethernet
rcvr-index
no sflow
rcvr-index — The sFlow Receiver for this sFlow sampler to which flow
•
samples are to be sent. If no receiver is configured, then no packets will be
sampled. Only active receivers can be set. If a receiver expires, then all
samplers associated with the receiver will also expire. (Range: 1–8).
interfaces — The list of interfaces to poll.
•
sampling-rate — The statistical sampling rate for packet sampling from this
•
source. A sampling rate of 1 counts all packets. A rate of 0 disables
sampling. A value of n means that out of n incoming packets, 1 packet will
be sampled. (Range: 1024–65536).
size —The maximum number of bytes that should be copied from the
•
sampler packet (Range: 20–256 bytes).
Default Configuration
There are no samplers configured by default.
The default sampling rate is 0.
interfaces sampling-rate
sampling ethernet
interfaces
Sflow Commands
[ size ]
1225