Show Ipv6 Traffic - Dell PowerConnect 6224 Command Line Interface Manual

Example
The following example displays a summary of the routing table.
console#show ipv6 route summary
IPv6 Routing Table Summary - 0 entries
Connected Routes............................... 0
Static Routes.................................. 0
OSPF Routes.................................... 0
Intra Area Routes............................ 0
Inter Area Routes............................ 0
External Type-1 Routes....................... 0
External Type-2 Routes....................... 0
Total routes................................... 0
Number of Prefixes:

show ipv6 traffic

Use the show ipv6 traffic command in User EXEC mode to show traffic and
statistics for IPv6 and ICMPv6.
Syntax
show ipv6 traffic [vlan
vlan-id — Valid VLAN ID, shows information about traffic on a specific
•
interface or, without the optional parameter, shows information about
traffic on all interfaces.
• tunnel — Tunnel identifier. (Range: 0-7)
• loopback — Loopback identifier. (Range: 0-7)
Default Configuration
This command has no default configuration.
816
IPv6 Routing Commands
vlan-id
| tunnel
tunnel-id
| loopback
loopback-id
]