Dell PowerConnect 6224 Command Line Interface Manual page 620

Default Configuration
The default value for the
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Change the default value of this command only to adjust for unusual
circumstances, such as unreliable links or specific behavioral problems with
certain clients and authentication servers.
Example
The following example sets the number of times that the switch sends an
EAP-request/identity frame to 6.
console(config)# interface ethernet 1/g16
console(config-if-1/g16)# dot1x max-req 6
dot1x max-users
Use the dot1x max-users command in Interface Configuration mode to set
the maximum number of clients supported on the port when MAC-based
802.1X authentication is enabled on the port. Use the no version of the
command to reset the maximum number of clients supported on the port
when MAC-based 802.1X authentication is enabled on the port. The value
would be reset to 8.
Syntax
dot1x max-users
no dot1x max-users
users — The number of users the port supports for MAC-based 802.1X
•
authentication (Range: 1–16)
Default Configuration
The default number of clients supported on a port with MAC-based 802.1X
authentication is 8.
620
802.1x Commands
count
parameter is 2.
users