console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf dead-interval 100
ipv6 ospf hello-interval
Use the ipv6 ospf hello-interval command in Interface Configuration mode
to set the OSPF hello interval for the specified interface.
Syntax
ipv6 ospf hello-interval
no ipv6 ospf hello-interval
seconds — A valid positive integer which represents the length of time of
•
the OSPF hello interval. The value must be the same for all routers
attached to a network. (Range: 1-65535 seconds)
Default Configuration
10 seconds is the default value of
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF hello interval at 15 seconds.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf hello-interval 15
ipv6 ospf mtu-ignore
Use the ipv6 ospf mtu-ignore command in Interface Configuration mode to
disable OSPF maximum transmission unit (MTU) mismatch detection.
OSPF Database Description packets specify the size of the largest IP packet
that can be sent without fragmentation on the interface. When a router
seconds
seconds
.
OSPFv3 Commands
955