Authentication Timeout; Captive-Portal - Dell PowerConnect 6224 Command Line Interface Manual

Captive Portal Global Commands

authentication timeout

Use the authentication timeout command to configure the authentication
timeout. If the user does not enter valid credentials within this time limit, the
authentication page needs to be served again in order for the client to gain
access to the network. Use the "no" form of this command to reset the
authentication timeout to the default.
Syntax
timeout
authentication timeout
no authentication timeout
timeout —The authentication timeout (Range: 60–600 seconds).
•
Default Configuration
The default authentication timeout is 300 seconds.
Command Mode
Captive Portal Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP)#authentication timeout 600
console(config-CP)#no authentication timeout

captive-portal

Use the captive-portal command to enter the captive portal configuration
mode.
1061
Captive Portal Commands