Dell PowerConnect 6224 Command Line Interface Manual page 702

ip igmp-proxy
Use the ip igmp-proxy command in Interface Configuration mode to enable
the IGMP Proxy on the router. To enable the IGMP Proxy on the router,
multicast forwarding must be enabled and there must be no multicast routing
protocols enabled on the router.
Syntax
ip igmp-proxy
no ip igmp-proxy
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example enables the IGMP Proxy on the VLAN 15 router.
console(config)#interface vlan 15
console(config-if-vlan15)#ip igmp-proxy
ip igmp-proxy reset-status
Use the ip igmp-proxy reset-status command in Interface Configuration
mode to reset the host interface status parameters of the IGMP Proxy router.
This command is valid only when IGMP Proxy is enabled on the interface.
Syntax
ip igmp-proxy reset-status
702
IGMP Proxy Commands