Tunnel Mode Ipv6Ip - Dell PowerConnect 6224 Command Line Interface Manual

ipv4addr — Valid ipv4 address.
•
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Tunnel) mode.
User Guidelines
This command has no user guidelines.
Example
The following example specifies the destination transport address of tunnel 1.
console(config)#interface tunnel 1
console(config-if-tunnel1)#tunnel destination
10.1.1.1

tunnel mode ipv6ip

Use the tunnel mode ipv6ip command in Interface Configuration mode to
specify the mode of the tunnel.
Syntax
tunnel mode ipv6ip [6to4]
no tunnel mode
6to4 — Sets the tunnel mode to automatic.
•
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Tunnel) mode.
1034
Tunnel Interface Commands