Dell PowerConnect 6224 Command Line Interface Manual page 348

Example
The following example configures the snooping querier to participate in the
querier election.
console(config-vlan)#ip igmp snooping querier
election participate
ip igmp snooping querier query-interval
This command sets the IGMP Querier Query Interval time, which is the
amount of time in seconds that the switch waits before sending another
periodic query. The no form of this command sets the IGMP Querier Query
Interval time to its default value.
Syntax
ip igmp snooping querier query-interval
no ip igmp snooping querier query-interval
seconds — Amount of time in seconds that the switch waits before
•
sending another general query. (Range: 1-1800)
Default Configuration
The query interval default is 60 seconds.
Command Mode
Global Configuration mode
User Guidelines
The value of this parameter should be larger than the IGMP Snooping Max
Response Time.
Example
The following example sets the query interval to 1800:
ip igmp snooping querier query_interval 1800
348
IGMP Snooping Querier Commands
seconds