User Guidelines
The timeout should be more than sum of response time and twice the query
interval.
Example
The following example configures the host timeout to 300 seconds.
console(config-if-1/g1)#ip igmp snooping host-time-
out 300
ip igmp snooping leave-time-out
Use the ip igmp snooping leave-time-out command in Interface
Configuration mode to configure the leave-time-out. If an IGMP report for a
Multicast group is not received within the leave-time-out period after an
IGMP leave was received from a specific port, the current port is deleted from
the member list of that Multicast group. To configure the default leave-time-
out, use the no form of this command.
Syntax
ip igmp snooping leave-time-out [
no ip igmp snooping leave-time-out
time-out — Specifies the leave-time-out in seconds. (Range: 1 - 3174)
•
immediate-leave
•
immediately from the members list after receiving IGMP Leave.
Default Configuration
The default leave-time-out configuration is 10 seconds.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
The leave timeout should be set greater than the maximum time that a host
is allowed to respond to an IGMP Query.
334
IGMP Snooping Commands
time-out |
— Specifies that the port should be removed
immediate-leave]