Dell PowerConnect 6224 Command Line Interface Manual page 371

portvalue — The source layer 4 port match condition for the ACL rule is
•
specified by the port value parameter. (Range: 0–65535).
destination ipv6 prefix — IPv6 prefix in IPv6 global address format.
•
value — The value to match in the Flow Label field of the IPv6
• flow label
header (Range 0–1048575).
dscp — Specifies the TOS for an IPv6 ACL rule depending on a
• dscp
match of DSCP values using the parameter dscp.
• log — Specifies that this rule is to be logged.
• assign-queue
traffic that matches the rule. (Range: 0-6)
interface — Allows the traffic matching this rule to be copied to the
• mirror
specified interface.
interface — This parameter allows the traffic matching this rule to
• redirect
be forwarded to the specified interface.
Default Configuration
This command has no default configuration.
Command Mode
Ipv6-Access-List Configuration mode
User Guidelines
Users are permitted to add rules, but if a packet does not match any user-
specified rules, the packet is dropped by the implicit "deny all" rule.
The 'no' form of this command is not supported, since the rules within an
IPv6 ACL cannot be deleted individually. Rather, the entire IPv6 ACL must
be deleted and re specified.
Example
The following example creates rules in an IPv6 ACL named "STOP_HTTP"
to discard any HTTP traffic from the 2001:DB8::/32 network, but allow all
other traffic from that network:
console(config)#ipv6 access-list STOP_HTTP
queue-id — Specifies particular hardware queue for handling
IPv6 Access List Commands
371