New Holland T8010 Manual page 1524

Hide thumbs Also See for T8010:

Table of Contents

5. Check the wiring harness to the PTO shaft speed sensor.

Check the continuity from Pin 20 of connector C058 to Pin A of connector C145.

Check the continuity from Pin B of connector C145 to the chassis ground.

6. Check the function of the PTO speed sensor. It should have resistance of about 3 K ohms.

NOTE: Always inspect connector ends for damaged, bent or dislocated pins when troubleshooting.

NOTE: See schematic sections 49 and 50 on the schematic poster.

Section 55 - Electrical System, Controller - Chapter 3

Chapters

Table of Contents

T8020 T8030 T8040