Updating Revolution Counters - ABB IRB 390 Product Manual

6 Calibration

6.3 Updating revolution counters

6.3 Updating revolution counters
Introduction
This section describes how to do a rough calibration of each manipulator axis by
updating the revolution counter for each axis, using the FlexPendant.
Step 1 - Manually running the manipulator to the synchronization position
Use this procedure to manually run the manipulator to the synchronization position.
1
2
3
Step 2 - Updating the revolution counter with the FlexPendant
Use this procedure to update the revolution counter with the FlexPendant (IRC5).
1
Continues on next page
302
Action
Select axis-by-axis motion mode.
Jog the manipulator to align the synchron-
ization marks.
When all axes are positioned, update the
revolution counter.
Action
On the ABB menu, tap Calibration.
xx1500000942
© Copyright 2020 - 2021 ABB. All rights reserved.
Note
See Synchronization marks and synchron-
ization position for axes on page
Step 2 - Updating the revolution counter
with the FlexPendant on page
Product manual - IRB 390
3HAC066566-001 Revision: B
300.
302.