Setting Up A Point-To-Point Connection; To Set Up A Point-To-Point Connection With An Emulation Module - Agilent Technologies E5900B User Manual

Connecting the Emulation Probe to a LAN

Setting up a Point-to-Point Connection

Setting up a Point-to-Point Connection
A point-to-point connection creates an isolated network with only two
nodes—the logic analysis system and the emulation probe.
There are two ways to set up the connection:
If you have this equipment..
Emulation probe and a logic
analysis system with an E5901B
emulation module
Emulation probe and a logic
analysis system without an
E5901B emulation module
To set up a point-to-point connection with an
emulation module
1 Connect the emulation module to the emulation probe (page 45).
2 Connect the crossover LAN cable between the logic analysis system
and the emulation probe.
3 In the logic analysis system main window, open the System
Administration dialog and check that networking is enabled.
4 Select the emulation module icon then select 6WDUW 6HVVLRQ .
This will automatically configure the LAN connection and start the Emulation
Control Interface. There is no need to set the IP address of the emulation
probe.
36
Use this procedure
"To set up a point-to-point connection with an
emulation module" on page 36
"To set up a point-to-point connection without
an emulation module" on page 37
E5900B / E5901B User's Guide Supplement