Danfoss VLT AutomationDrive FC 301 Programming Manual page 47

Parameter Descriptions
0-40 [Hand on] Key on LCP
Option: Function:
password in parameter 0-60 Main
Menu Password.
[3] Hand Off/On When [Hand On] is pressed once,
the LCP switches to Off mode.
When pressed again, the LCP
switches to hand-on mode.
[4] Hand Off/On Same as option [3] Hand Off/On but
w. Passw. a password is required (see option
[2] Password).
[9] Enabled, ref =
0
0-41 [Off] Key on LCP
Option: Function:
[0] Disabled Avoids accidental stop of the
frequency converter.
[1] Enabled
[2] Password Avoids unauthorized stop. If
parameter 0-41 [Off] Key on LCP is
included in the Quick Menu, then
define the password in
parameter 0-65 Personal Menu
Password.
0-42 [Auto on] Key on LCP
Option: Function:
[0] Disabled Avoids accidental start of the
frequency converter in auto-on
mode.
[1] Enabled
[2] Password Avoids unauthorized start in auto-
on mode. If parameter 0-42 [Auto
on] Key on LCP is included in the
Quick Menu, then define the
password in parameter 0-65 Personal
Menu Password.
0-43 [Reset] Key on LCP
Option: Function:
[0] Disabled No effect when [Reset] is pressed.
Avoids accidental alarm reset.
[1] Enabled
[2] Password Avoids unauthorized resetting. If
parameter 0-43 [Reset] Key on LCP is
included in the Quick Menu, then
define the password in
parameter 0-65 Personal Menu
Password.
[7] Enabled Resets the frequency converter
without OFF without setting it in Off mode.
M0013101
Programming Guide
0-43 [Reset] Key on LCP
Option:
[8]
0-44 [Off/Reset] Key on LCP
Enable or disable the [Off/Reset] key.
Option:
[0]
[1]
*
[2]
0-45 [Drive Bypass] Key on LCP
Press [Off] and select [0] Disabled to avoid unintended stop of
the frequency converter. Press [Off] and select [2] Password to
avoid unauthorized bypass of the frequency converter. If
parameter 0-45 [Drive Bypass] Key on LCP is included in the Quick
Menu, define the password in parameter 0-65 Personal Menu
Password.
Option:
[0]
[1]
*
[2]
3.1.6 0-5* Copy/Save
Copy parameters from and to the LCP. Use these
parameters for saving and copying set-ups from 1
frequency converter to another.
0-50 LCP Copy
Option:
[0]
*
[1]
[2]
[3]
Danfoss A/S © 10/2019 All rights reserved.
Function:
Password Resets the frequency converter
without OFF without setting it in Off mode. A
password is required when pressing
[Reset] (see option [2] Password).
Function:
Disabled
Enabled
Password
Function:
Disabled Select to disable the key.
Enabled
Password
Function:
NOTICE
This parameter cannot be
adjusted while the motor is
running.
No copy
All to LCP Copies all parameters in all set-ups
from the frequency converter
memory to the LCP memory.
All from LCP Copies all parameters in all set-ups
from the LCP memory to the
frequency converter memory.
Size indep. Copy only the parameters that are
from LCP independent of the motor size. The
latter selection can be used to
program several frequency
converters with the same function
without disturbing motor data.
3 3
45