Danfoss VLT AutomationDrive FC 301 Programming Manual page 136

Parameter Descriptions
5-20 Terminal X46/1 Digital Input
Option:
[70] Mech. Brake
Feedb.
[71] Mech. Brake
3 3
Feedb. Inv.
[72] PID error
inverse
[73] PID reset I
part
[74] PID enable
[75] MCO Specific
[78] Reset Maint.
Word
[80] PTC Card 1
[91] Profidrive
OFF2
[92] Profidrive
OFF3
[94] Light Load
Detection
[95] Evacuation
mode
[96] Mains Loss
[97] Mains Loss
Inverse
[98] Start edge
triggered
[100] Safe Option
Reset
[106] Set Master
Home
[107] Target Inverse
[108] Enable Mast.
Offset
[109] Enable Vir.
Master
[110] Start Homing
[111] Activate Touch
[112] Relative
Position
[113] Enable
Reference
[114] Sync. to Pos.
Mode
[115] Home Sensor
[116] Home Sensor
Inv.
[117] Touch Sensor
[118] Touch Sensor
Inv.
[119] Speed Mode
[122] Position Vir.
Master
[123] Master Marker
134
®
VLT AutomationDrive FC 301/302
Function:
Danfoss A/S © 10/2019 All rights reserved.
5-20 Terminal X46/1 Digital Input
Option: Function:
[124] Master Marker
Inv.
[125] Follower
Marker
[126] Follow. Marker
Inv.
[231] Power Limit
Mot.
[232] Power Limit
Gen.
[233] Power Limit
Both
[234] Light Load
+Evacuation
5-21 Terminal X46/3 Digital Input
Option: Function:
[0] No operation This parameter is active when
*
option module VLT
Card MCB 113 is installed in the
frequency converter. Functions are
described in parameter group 5-1*
Digital Inputs.
[1] Reset
[2] Coast inverse
[3] Coast and
reset inv
[4] Quick stop
inverse
[5] DC-brake
inverse
[6] Stop inverse
[8] Start
[9] Latched start
[10] Reversing
[11] Start reversing
[12] Enable start
forward
[13] Enable start
reverse
[14] Jog
[15] Preset
reference on
[16] Preset ref bit 0
[17] Preset ref bit 1
[18] Preset ref bit 2
[19] Freeze
reference
[20] Freeze output
[21] Speed up
[22] Speed down
[23] Set-up select
bit 0
®
Extended Relay
M0013101