Danfoss VLT AutomationDrive FC 301 Programming Manual page 250

Parameter Descriptions
15-32 Fault Log: Time
Array [10]
Range:
0 s
*
2147483647 s]
3 3
15-33 Fault log: Date and Time
Array [10]
Range:
Size
related
*
3.15.9 15-4* Drive Identification
Parameters containing read-only information about the
hardware and software configuration of the frequency
converter.
15-40 FC Type
Range:
0
*
15-41 Power Section
Range:
0
*
15-42 Voltage
Range:
0
*
15-43 Software Version
Range:
0
*
15-44 Ordered Typecode String
Range:
0
*
248
Function:
[0 - View the time when the logged
event occurred. Time is measured in
s from frequency converter start-up.
Function:
[ 0 - 0 ] Array parameter; Date & Time 0–9:
This parameter shows when the
logged event occurred.
Function:
[0 - 6 ] View the frequency converter type.
The readout is identical to the FC
300 power field of the type code
definition, characters 1–6.
Function:
[0 - 20 ] View the frequency converter type.
The readout is identical to the FC
300 power field of the type code
definition, characters 7–10.
Function:
[0 - 20 ] View the frequency converter type.
The readout is identical to the FC
300 power field of the type code
definition, characters 11–12.
Function:
[0 - 5 ] View the combined SW version (or
package version) consisting of
power SW and control SW.
Function:
[0 - 40 ] View the type code string used for
reordering the frequency converter
in its original configuration.
Danfoss A/S © 10/2019 All rights reserved.
®
VLT AutomationDrive FC 301/302
15-45 Actual Typecode String
Range:
0
*
15-46 Frequency Converter Ordering No
Range:
0
*
15-47 Power Card Ordering No
Range:
0
*
15-48 LCP Id No
Range:
0
*
15-49 SW ID Control Card
Range:
0
*
15-50 SW ID Power Card
Range:
0
*
15-51 Frequency Converter Serial Number
Range:
0
*
15-53 Power Card Serial Number
Range:
0
*
15-54 Config File Name
Array [5]
Range:
Size
related
*
15-58 Smart Setup Filename
Range:
Size
related
*
Function:
[0 - 40 ] View the actual type code string.
Function:
[0 - 8 ] View the 8-digit order number used
for reordering the frequency
converter in its original configu-
ration. To restore the order number
after the power card exchange, see
parameter 14-29 Service Code.
Function:
[0 - 8 ] View the power card order number.
Function:
[0 - 20 ] View the LCP ID number.
Function:
[0 - 20 ] View the control card software
version number.
Function:
[0 - 20 ] View the power card software
version number.
Function:
[0 - 10 ] View the frequency converter serial
number.
Function:
[0 - 19 ] View the power card serial number.
Function:
[0 - 16 ] Shows the special configuration
filenames.
Function:
[0 - 20 ] Shows the SmartStart filename.
M0013101