Danfoss VLT AutomationDrive FC 301 Programming Manual page 188

Parameter Descriptions
8-13 Configurable Status Word STW
This is an array parameter with 16 elements, 1 element for each
bit in range 0–15. Elements 5 and 11–15 are configurable. Each
of the bits can be configured to any of the following options.
Option:
3 3
[17] X30/2 DI
status
[18] X30/3 DI
status
[19] X30/4 DI
status
[20] CTW Timeout
Toggle Inverse
[21] Thermal
warning
[30] Brake fault
(IGBT)
[40] Out of ref
range
[49] Derate active
[54] Running
[59] On Reference
[60] Comparator 0
[61] Comparator 1
[62] Comparator 2
[63] Comparator 3
[64] Comparator 4
[65] Comparator 5
[70] Logic Rule 0
[71] Logic Rule 1
[72] Logic Rule 2
[73] Logic Rule 3
[74] Logic Rule 4
[75] Logic Rule 5
[80] SL digital out
A
[81] SL digital out
B
[82] SL digital out
C
[83] SL digital out
D
[84] SL digital out
E
[85] SL digital out
F
[86] ATEX ETR cur.
alarm
[87] ATEX ETR freq.
alarm
[88] ATEX ETR cur.
warning
[89] ATEX ETR freq.
warning
186
®
VLT AutomationDrive FC 301/302
Function:
Danfoss A/S © 10/2019 All rights reserved.
8-13 Configurable Status Word STW
This is an array parameter with 16 elements, 1 element for each
bit in range 0–15. Elements 5 and 11–15 are configurable. Each
of the bits can be configured to any of the following options.
Option: Function:
[90] Safe Function
active
[91] Safe Opt.
Reset req.
[92] IGBT-cooling See parameter group 5-3* Digital
Outputs.
[181] Prev.
Maintenance
[200] User Defined
Alerts
[231] In Power Lim. See parameter group 4-8* Power
Mot. Limit. Use this option in motor
mode only.
[232] In Power Lim. See parameter group 4-8* Power
Gen. Limit. Use this option in generating
mode only.
[233] In Power Limit See parameter group 4-8* Power
Limit. Use this option in both the
motor and the generating modes.
8-13 Configurable Status Word STW
Option: Function:
NOTICE
Options in this block are only
available for software version
8.XX.
[0] No function The input is always low.
[1] Profile Default Depended on the profile set in
parameter 8-10 Control Profile.
[2] Alarm 68 Only The input goes high whenever
Alarm 68 Safe Stop Activated is
active and goes low whenever
Alarm 68 Safe Stop Activated is not
activated.
[3] Trip excl
Alarm 68
[10] T18 DI status
[11] T19 DI status
[12] T27 DI status
[13] T29 DI status
[14] T32 DI status
[15] T33 DI status
[16] T37 DI status The input goes high whenever T37
has 0 V and goes low whenever
T37 has 24 V.
M0013101