Danfoss VLT AutomationDrive FC 301 Programming Manual page 214

Parameter Descriptions
13-15 RS-FF Operand S
Option:
[225] Position Limit
3 3
[226] Touch on
Target
[227] Touch
Activated
13-16 RS-FF Operand R
Option:
[0] False
[1] True
[2] Running
[3] In range
[4] On reference
[5] Torque limit
[6] Current Limit
[7] Out of current
range
[8] Below I low
[9] Above I high
[10] Out of speed
range
[11] Below speed
low
[12] Above speed
high
[13] Out of feedb.
range
[14] Below feedb.
low
[15] Above feedb.
high
212
®
VLT AutomationDrive FC 301/302
Function:
NOTICE
This option is available only
with software version 48.20
and newer.
The position is outside the limits
set in parameter 3-06 Minimum
Position and
parameter 3-07 Maximum Position.
NOTICE
This option is available only
with software version 48.20
and newer.
Target position is reached in touch
probe position mode.
NOTICE
This option is available only
with software version 48.20
and newer.
Touch probe positioning active. The
frequency converter monitors the
touch probe sensor input.
Function:
Danfoss A/S © 10/2019 All rights reserved.
13-16 RS-FF Operand R
Option: Function:
[16] Thermal
warning
[17] Mains out of
range
[18] Reversing
[19] Warning
[20] Alarm (trip)
[21] Alarm (trip
lock)
[22] Comparator 0
[23] Comparator 1
[24] Comparator 2
[25] Comparator 3
[26] Logic rule 0
[27] Logic rule 1
[28] Logic rule 2
[29] Logic rule 3
[30] SL Time-out 0
[31] SL Time-out 1
[32] SL Time-out 2
[33] Digital input
DI18
[34] Digital input
DI19
[35] Digital input
DI27
[36] Digital input
DI29
[37] Digital input
DI32
[38] Digital input
DI33
[39] Start
command
[40] Drive stopped
[41] Reset Trip
[42] Auto-reset Trip
[43] Ok key [OK] is pressed. Only available on
the graphical LCP.
[44] Reset key [Reset] is pressed. Only available on
the graphical LCP.
[45] Left key [◄] is pressed. Only available on the
graphical LCP.
[46] Right key [►] is pressed. Only available on the
graphical LCP.
▲
[47] Up key
[ ] is pressed. Only available on the
graphical LCP.
▼
[48] Down key
[ ] is pressed. Only available on the
graphical LCP.
[50] Comparator 4
[51] Comparator 5
M0013101