Danfoss VLT AutomationDrive FC 301 Programming Manual page 160

Parameter Descriptions
5-60 Terminal 27 Pulse Output Variable
Option:
[99] Virtual Master
Speed
3 3
[100] Output
frequency
[101] Reference
[102] Feedback
[103] Motor Current
[104] Torque rel to
limit
[105] Torq relate to
rated
[106] Power
[107] Speed
[108] Torque
[109] Max Out Freq
[119] Torque % lim
5-62 Pulse Output Max Freq #27
Range:
Size
related Hz]
*
5-63 Terminal 29 Pulse Output Variable
Option:
[0] No operation
[45] Bus ctrl.
[48] Bus ctrl.,
timeout
[51] MCO
controlled
[97] Reference
After Ramp
158
Function:
NOTICE
This option is available only
with software version 48.XX.
Virtual master signal for controlling
the speed or position of the
followers.
Function:
[0 - 110000 Set the maximum frequency for
terminal 27 corresponding to the
output variable selected in
parameter 5-60 Terminal 27 Pulse
Output Variable.
Function:
NOTICE
This parameter is available for
FC 302 only.
Select the display output for
terminal 29.
NOTICE
This option is available only
with software version 48.XX.
Actual speed reference after the
ramp. Use this output as master
signal for speed synchronization of
follower frequency converters. The
Danfoss A/S © 10/2019 All rights reserved.
®
VLT AutomationDrive FC 301/302
5-63 Terminal 29 Pulse Output Variable
Option:
[99]
[100]
[101]
[102]
[103]
[104]
[105]
[106]
[107]
[108]
[109]
[119]
5-65 Pulse Output Max Freq #29
Range:
Size
related
*
5-66 Terminal X30/6 Pulse Output Variable
Select the variable for readout on terminal X30/6.
This parameter is active when VLT
is installed in the frequency converter.
Same options and functions as parameter group 5-6* Pulse
Outputs.
Option:
[0]
[45]
[48]
[51]
Function:
reference is set in
parameter 16-48 Speed Ref. After
Ramp [RPM].
NOTICE
Virtual Master
Speed
This option is available only
with software version 48.XX.
Virtual master signal for controlling
the speed or position of the
followers.
Output
frequency
Reference
Feedback
Motor Current
Torque rel to
limit
Torq relate to
rated
Power
Speed
Torque
Max Out Freq
Torque % lim
Function:
[0 - 110000 Set the maximum frequency for
Hz] terminal 29 corresponding to the
output variable set in
parameter 5-63 Terminal 29 Pulse
Output Variable.
®
General Purpose I/O MCB 101
Function:
No operation
Bus ctrl.
Bus ctrl.,
timeout
MCO
controlled
M0013101