Danfoss VLT AutomationDrive FC 301 Programming Manual page 147

Parameter Descriptions
NOTICE
[224] Position Limit
This option is available only with
software version 48.XX.
The position error exceeds the value in
parameter 4-71 Maximum Position Error for
the time set in parameter 4-72 Position Error
Timeout.
NOTICE
[225] Position Error
This option is available only with
software version 48.XX.
The position is outside the limits set in
parameter 3-06 Minimum Position and
parameter 3-07 Maximum Position.
NOTICE
[226] Touch on Target
This option is available only with
software version 48.XX.
Target position is reached in touch probe
position mode.
NOTICE
[227] Touch Activated
This option is available only with
software version 48.XX.
Touch probe positioning active. The
frequency converter monitors the touch
probe sensor input.
[231] In Power Lim.
Mot.
[232] In Power Lim.
Gen.
[233] In Power Limit
5-30 Terminal 27 Digital Output
Option: Function:
[0] No operation Functions are described in parameter group
5-3* Digital Outputs.
5-31 Terminal 29 Digital Output
Option: Function:
NOTICE
This parameter is applicable
for FC 302 only.
[0] No operation Functions are described in
parameter group 5-3* Digital
Outputs.
[1] Control Ready
[2] Drive ready
[3] Drive rdy/rem
ctrl
[4] Enable / no
warning
[5] Running
[6] Running / no
warning
M0013101
Programming Guide
5-31 Terminal 29 Digital Output
Option:
[7]
[8]
[9]
[10]
[11]
[12]
[13]
[14]
[15]
[16]
[17]
[18]
[19]
[20]
[21]
[22]
[23]
[24]
[25]
[26]
[27]
[28]
[29]
[30]
[31]
[32]
[33]
[35]
[38]
Danfoss A/S © 10/2019 All rights reserved.
Function:
Run in
range/no warn
Run on ref/no
warn
Alarm
Alarm or
warning
At torque limit
Out of current
range
Below current,
low
Above current,
high
Out of speed
range
Below speed,
low
Above speed,
high
Out of feedb.
range
Below
feedback, low
Above
feedback, high
Thermal
warning
Ready,no
thermal W
Remote,ready,
no TW
Ready, Voltage
OK
Reverse
Bus OK
Torque limit &
stop
Brake, no
brake war
Brake ready,
no fault
Brake fault
(IGBT)
Relay 123
Mech brake
ctrl
Safe stop
active
External
Interlock
Motor
feedback error
3 3
145