Danfoss VLT AutomationDrive FC 301 Programming Manual page 279

Parameter Descriptions
NOTICE
The preventive maintenance events are defined in a 20-element array. Hence, each preventive maintenance event must
use the same array element index in parameter 23-10 Maintenance Item to parameter 23-14 Maintenance Date and Time.
23-10 Maintenance Item
Array [20]
Option: Function:
Array with 20 elements shown
below the parameter number in the
display. Press [OK] and step
between elements with [◄], [►], [
and [
Select the item to be associated
with the preventive maintenance
event.
[1] Motor
*
bearings
[11] Drive cooling
fan
[12] System health
check
[13] Warranty
[14] Mech Brake
[20] Maintenance
Text 0
[21] Maintenance
Text 1
[22] Maintenance
Text 2
[23] Maintenance
Text 3
[24] Maintenance
Text 4
[25] Maintenance
Text 5
[26] Service log full
23-11 Maintenance Action
Array [20]
Option: Function:
Select the action to be associated
with the preventive maintenance
event.
[1] Lubricate
*
[2] Clean
[3] Replace
[4] Inspect/Check
[5] Overhaul
[6] Renew
[7] Check
[20] Maintenance
Text 0
M0013101
Programming Guide
▲
],
▼
].
Danfoss A/S © 10/2019 All rights reserved.
23-11 Maintenance Action
Array [20]
Option: Function:
[21] Maintenance
Text 1
[22] Maintenance
Text 2
[23] Maintenance
Text 3
[24] Maintenance
Text 4
[25] Maintenance
Text 5
[28] Clear logs
23-12 Maintenance Base
Array [20]
Option: Function:
Select the time base to be
associated with the preventive
maintenance event.
[0] Disabled Disables the preventive
*
maintenance event.
[1] Running Hours The number of hours the motor has
run. Running hours are not reset at
power-on. Specify the maintenance
time interval in
parameter 23-13 Maintenance
Interval.
[2] Operating The number of hours the frequency
Hours converter has run. Operating hours
are not reset at power-on. Specify
the maintenance time interval in
parameter 23-13 Maintenance
Interval.
[3] Date & Time Uses the internal clock. Specify the
date and time of the next
maintenance occurrence in
parameter 23-14 Maintenance Date
and Time.
[4] No of Counts
23-13 Maintenance Interval
Array [20]
Range: Function:
1 [1 - Set the interval associated with the
*
2147483647 ] current preventive maintenance
event. This parameter is only used if
[1] Running Hours or [2] Operating
3 3
277