Danfoss VLT AutomationDrive FC 301 Programming Manual page 223

Parameter Descriptions
13-44 Logic Rule Boolean 3
Array [6]
Option: Function:
alarm 166, ATEX ETR freq.lim.alarm is
active, the output is 1.
[92] ATEX ETR freq. Available if parameter 1-90 Motor
warning Thermal Protection is set to [20]
ATEX ETR or [21] Advanced ETR. If
alarm 163, ATEX ETR cur.lim.warning
is active, the output is 1.
[93] ATEX ETR freq. Available if parameter 1-90 Motor
alarm Thermal Protection is set to [20]
ATEX ETR or [21] Advanced ETR]. If
warning 165, ATEX ETR
freq.lim.warning is active, the output
is 1.
[94] RS Flipflop 0 See parameter group 13-1*
Comparators.
[95] RS Flipflop 1 See parameter group 13-1*
Comparators.
[96] RS Flipflop 2 See parameter group 13-1*
Comparators.
[97] RS Flipflop 3 See parameter group 13-1*
Comparators.
[98] RS Flipflop 4 See parameter group 13-1*
Comparators.
[99] RS Flipflop 5 See parameter group 13-1*
Comparators.
[100] RS Flipflop 6 See parameter group 13-1*
Comparators.
[101] RS Flipflop 7 See parameter group 13-1*
Comparators.
[102] Relay 1
[103] Relay 2
[104] Relay 3
X47/VLT
113.
[105] Relay 4
X47/VLT
113.
[106] Relay 5
X47/VLT
113.
[107] Relay 6
X47/VLT
113.
[108] Relay 7
X34/VLT
[109] Relay 8
X34/VLT
[110] Relay 9
X34/VLT
M0013101
Programming Guide
®
Extended Relay Card MCB
®
Extended Relay Card MCB
®
Extended Relay Card MCB
®
Extended Relay Card MCB
®
Relay Card MCB 105.
®
Relay Card MCB 105.
®
Relay Card MCB 105.
Danfoss A/S © 10/2019 All rights reserved.
13-44 Logic Rule Boolean 3
Array [6]
Option: Function:
NOTICE
[222] Homing Ok
This option is available only
with software version 48.20
and newer.
Homing is completed with the
selected homing function
(parameter 17-80 Homing Function).
NOTICE
[223] On Target
This option is available only
with software version 48.20
and newer.
Positioning is completed and the
on-target signal is sent when the
actual position is within
parameter 3-05 On Reference
Window for the duration of
parameter 3-09 On Target Time and
the actual speed does not exceed
parameter 3-05 On Reference
Window.
NOTICE
[224] Position Error
This option is available only
with software version 48.20
and newer.
The position error exceeds the
value in parameter 4-71 Maximum
Position Error for the time set in
parameter 4-72 Position Error
Timeout.
NOTICE
[225] Position Limit
This option is available only
with software version 48.20
and newer.
The position is outside the limits
set in parameter 3-06 Minimum
Position and
parameter 3-07 Maximum Position.
NOTICE
[226] Touch on
Target
This option is available only
with software version 48.20
and newer.
Target position is reached in touch
probe position mode.
3 3
221