Iq Rap 3 Spots - Xerox DocuPrint N2125 Service Manual

Network laser printer
Hide thumbs Also See for DocuPrint N2125:
Table of Contents

Advertisement

A
B
Check for continuity between the Metal Grounding Contacts and the printer frame. There
is continuity between the Grounding Contacts and the printer frame.
Y
N
Replace the Print Cartridge Side Guide
The BTR is intact and is free of contamination.
Y
N
Replace the BTR Assembly
(REP
Generate a Test Print and switch OFF the printer power halfway through the print cycle.
Carefully remove the Print Cartridge and inspect the toner image on the drum just before
the transfer area (BTR). The image on the drum is completely developed; with sharp,
black, easily read areas.
Y
N
Go to
RAP
43.
Replace in order until the problem is solved: HVPS PWB
(REP
7.4), BTR Assembly
(REP
7.1), Print Engine Controller PWB
(REP
9.5), Print Cartridge Side Guide
Problem solved.
Initial Issue
DocuPrint N2125
(REP
7.5).
7.1).
(REP
9.6), Laser Assembly
(REP
9.3), LVPS PWB
(REP
7.5).

IQ RAP 3 Spots

There are spots of toner randomly scattered on the page
Initial Actions
Check that the paper supply is clean, dry and fresh (recycled paper may have spots).
Ensure there are no obstructions in the Laser path.
Inspect the printer paper path for items such as staples, paper clips and paper scraps.
Check installation of the Print Cartridge.
Check that the Print Cartridge ground contact points are clean.
Check that rollers and other components in the paper path are clean and unobstructed.
Procedure
Install a new Print Cartridge. Run a Test Print. The spots are gone.
Y
N
Inspect the BTR Assembly for contamination and wear. The BTR is free of contamina-
tion and wear.
Y
N
Replace the BTR Assembly
Generate a Test Print and switch OFF the printer power halfway through the print cycle.
Carefully remove the Print Cartridge and inspect the toner image on the drum just before
the transfer area (BTR). The image on the drum is completely developed; with sharp,
black easily read areas and no spots.
Y
N
Go to
RAP
43.
A
B
02/2000
3-13
(Figure
1).
Figure 1 Spots
(REP
7.1).
Image Quality Repair Analysis Procedures
IQ RAP 2 , IQ RAP 3

Advertisement

Table of Contents
loading

Table of Contents