Maximum Bandwidth Per Call For Direct-Ip Multimedia (Units); Maximum Bandwidth Per Call For Direct-Ip Multimedia (Value); Maximum Call Rate For Priority Direct-Ip Multimedia; Maximum Call Rate For Direct-Ip Multimedia - Avaya G450 Configuration Manual

from changing into fax mode, set the FAX mode to off and place the fax machines in an
Automatic Route Selection (ARS) partition that uses only circuit switched trunks, even for
inter-gateway fax calls.

Maximum Bandwidth Per Call for Direct-IP Multimedia (units)

This field appears only if Allow Direct-IP Multimedia is enabled.
Valid Entry
kbits
mbits

Maximum Bandwidth Per Call for Direct-IP Multimedia (value)

This field appears only if Allow Direct-IP Multimedia is enabled.
Valid Entry
1 to 9999

Maximum Call Rate for Priority Direct-IP Multimedia

The system displays this field only if Allow Direct-IP Multimedia is set to y.

Maximum Call Rate for Direct-IP Multimedia

Use this field to limit the size of bandwidth used for video calls. The system displays this field
appears only if Allow Direct-IP Multimedia is set to y. The default value is 384 kilobits. You
can enter a value between 64 kilobits and 15360 kilobits, with an increment of 64 kilobits. A
typical video endpoint does not require more than 2048 kilobits.
Configuring V.150.1 on Avaya G450 and G430 Branch Gateway
Usage
The unit of measure corresponding to the value entered for bandwidth
limitation. The default measure is kbits.
Usage
The bandwidth limit for Direct-IP Multimedia transmissions on this codec
set. The default value is 256.
IP codec set
May 2014 33