Removing And Installing Slide Valve Body; Removing And Installing Atf Strainer - Skoda Octavia Workshop Manual

38
------------ ------------
Gear/Control
Tightening torques
Component
Overflow tube to oil pan
ATF screw plug to oil pan
Oil pan to gearbox housing (crosswise)
Protection plate to gearbox housing
Removing and installing ATF
strainer
Removing
- Remove oil pan ⇒ page 38-15
K - Detach ATF strainer from slide valve body.
Installing
- Insert intake collar of ATF strainer approxi-
mately 3 mm into the slide valve body (not
up to the stop). When installing the oil pan,
the ATF strainer must be pressed into the
correct installation position.
Note:
The gasket is vulcanised on the intake collar of
the ATF strainer.
- Install oil pan ⇒ page 38-15.
- Top up ATF after repair ⇒ page 37-25.
Removing and installing slide valve
body
Removing
- Shift selector lever into position „1".
- Remove oil pan ⇒ page 38-15.
- Remove ATF strainer ⇒ page 38-16.
- Unbolt bracket for plug of ribbon cable, re-
lease plug.
K - Loosen locking screw -1- for cable duct. Press
cable duct from inside to outside out of the
gearbox housing. Slacken bolts -arrows-.
OCTAVIA
Tightening
torque
2 Nm
15 Nm
12 Nm
50 Nm
Edition 06.03
S00.5116.60.20