Removing And Installing Ignition/Starter Switch - Skoda Octavia II 2004 Workshop Manual

– Remove steering column combination switch
– Disconnect the plug from the ignition starter switch and from
the reader coil.
– Bore out fixing screws -1- and remove steering lock -3- with
carrier of combination switch -2-.
– Press off catches -arrows- and remove carrier of combination
switch -1- from steering lock housing -2-.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Screw on steering lock with new pull-off screws and tighten
until the screw heads are torn off.
– Make sure that all the retaining lugs and plug connections lock
in place correctly.
8.4 Removing and installing ignition/starter
switch
Removing
– Disconnect battery earth strap
Note
The steering wheel must not be removed. For installing the fixing
screws of the bottom trim panel for steering column, turn the
steering wheel to the left by 90° and subsequently turn it to the
right.
– First of all remove the top and then the bottom steering column
trim panel ⇒ Body Work; Rep. gr. 70 .
– Release cover -1- (if present) for ignition starter switch by in‐
serting a small screwdriver in the opening -arrow- and lift off
the cover -movement arrow- through extensive levering off
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
and remove.
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.�
– Disconnect plug -3- from ignition starter switch -2-.
⇒ page 143
⇒ page 2 .
8. Steering lock with ignition starter switch and lock cylinder
Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
.
147