Figure D-3 Mic Terminal-Lug Power Connector - Cisco ONS 15327 Procedure Manual

NTP-B222 Connect Office Power to the ONS 15327 Shelf (Terminal-Lug Power Connector)
Figure D-3
Secure the lug using the screws provided.
Step 9
Step 10 Insert the battery (red) wire into the left hand (–48V) slot of the connector.
Make sure the flat part of the lug faces away from the center of the connector.
Warning
Secure the battery (–48V) wire using the screws provided.
Step 11
Place the plastic shroud over the power connector and plug the power connector into the MIC.
Step 12
Secure the connector to the shelf using the top left and bottom right screws.
Step 13
Figure D-4
Cisco ONS 15327 Procedure Guide, R4.0
D-6
MIC Terminal-Lug Power Connector
shows power cables connected to the terminal-lug power connector on the MIC.
Appendix D Alternate Installation Procedures
March 2003