Dlp-B316 Log Out A User - Multiple Nodes - Cisco ONS 15327 Procedure Manual

Chapter 9 Change Node Settings
On the Logout User dialog box, check Lockout before Logout if you want to prevent the user from
Step 3
logging in after logout. Parameters set under User Lockouts in the Policy tab determine when the user
can log back in. Either a manual unlock by a Superuser is required or the user is locked out for the
amount of time specified in the Lockout Duration field. See the
Policy - Single Node" task on page 9-17
Click OK.
Step 4
Step 5 Click Yes to confirm the logout.
Return to your originating procedure (NTP).
Step 6

DLP-B316 Log Out a User - Multiple Nodes

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 From the view menu, chose Go to Network View.
Click the Provisioning > Security > Active Logins tabs.
Step 2
Choose the user you want to log out.
Step 3
Click Logout.
Step 4
On the Logout User dialog box, check the nodes where you want to log out the user.
Step 5
Check Lockout before Logout if you want to prevent the user from logging in after logout. Parameters
Step 6
set under User Lockouts in the Policy tab determine when the user can log back in. Either a manual
unlock by a Superuser is required or the user is locked out for the amount of time specified in the Lockout
Duration field. See the
more information.
Click OK.
Step 7
Click Yes to confirm the logout.
Step 8
Return to your originating procedure (NTP).
Step 9
March 2003
for more information.
Use this task to log out a user from multiple nodes.
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Superuser
"DLP-B271 Change Node Security Policy - Single Node" task on page 9-17
NTP-B205 Modify Users and Change Security
"DLP-B271 Change Node Security
Cisco ONS 15327 Procedure Guide, R4.0
for
9-21