Dlp-B 165 Change Line And Threshold Settings For The Ds-1 Ports - Cisco ONS 15327 Procedure Manual

NTP-B88 Modify Line Settings and PM Parameter Thresholds for Electrical Ports
Complete the
Step 1
card/port settings.
Complete the
Step 2
database.
Perform either of the following tasks as needed:
Step 3
•
•
Step 4 When you are finished changing the port settings, complete the
procedure on page
Stop. You have completed this procedure.
DLP-B165 Change Line and Threshold Settings for the DS-1 Ports
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note The ONS 15327 XTC cards provide 14 (XTC-14) or 28 (XTC-28-3) DS-1 ports. Each port operates at
1.544 Mbps. Default thresholds are based on recommendations in GR-820-CORE, Section 4.0.
In node view, double-click the XTC card where you want to change the DS-1 line or threshold settings.
Step 1
Click the Provisioning > DS-1 tabs
Step 2
Cisco ONS 15327 Procedure Guide, R4.0
10-2
"DLP-B60 Log into CTC" task on page 2-23
"NTP-B108 Back Up the Database" procedure on page 14-6
DLP-B165 Change Line and Threshold Settings for the DS-1 Ports, page 10-2
DLP-B166 Change Line and Threshold Settings for the DS-3 Ports, page 10-6
14-6.
This task changes the line and threshold settings for the DS-1 ports. The
default DS-1 port settings are listed in
None
DLP-B60 Log into CTC, page 2-23
As needed
Onsite or remote
Provisioning or higher
at the node where you want to change the
(Figure 10-1).
Chapter 10 Change Port Settings
to preserve the existing
"NTP-B108 Back Up the Database"
Table C-1 on page C-5.
March 2003